Staff Report - Laserfiche WebLink

connection width shall not exceed 35 feet. A public access easement shall be recorded and submitted to the city upon issuance of a permit to construct the access connection. This standard is not applicable as the proposed development does not include, and is not adjacent to, an alley. (2) Access Connections to Arterial and Major Collector Streets. These standards are not applicable as the subject site is not located on an Arterial or Major Collector street. (3) Access Connections to Local and Neighborhood Collector Streets. In addition to the location standards set forth in EC 7.420(1), access connections to local and neighborhood collector streets shall be located in accordance with the following standards: (a)Lots and parcels at intersections shall have the access connection begin no less than 20 feet from the end of the radius of the curb, or 20 feet from the property corner if there is no curb. At the time of the building permit for Lot 3, 20, 21 and 26 the access connection will not be permitted to be located less than 20 feet from the end of the curb return. (b) A safety island of not less than 22 feet of full height curb shall in all cases be provided between access connections under one ownership. Compliance with this standard will be determined at the time of the building permit when precise access connection locations have been determined. Based on these findings and future permit requirements, the proposed development will comply with the applicable access connection standards. (g) EC 9.6750 Special Setback Standards. No special setbacks are required for future right-of-way or public utility easements. As discussed previously at EC 9.6805 and EC 9.6870, Capital Drive complies with applicable right- of-way width requirements. (h) EC 9.6775 Underground Utilities. All on- site plans, consistent with EC 9.6775. Capital Hill PUD (PDT 17-1) February 2018 47 Page 47